Filter
Top Products
Operating _15
02 OPERATING
After a few
seconds, the Fridge will begin adjusting
towards the newly set temperature. This will be
reflected in the digital display.
- The temperature of the Freezer, Fridge or Flex
Zone may rise when you open the doors too
frequently, or if a large amount of warm or hot
food is placed inside.
- This may cause the digital display to blink. Once
the Freezer and Fridge temperature return to their
normal set temperatures, the blinking will stop.
- If the blinking continues, you may need to “reset”
the Refrigerator. Try unplugging the appliance,
wait for around 10 minutes and then plug the
power cord back in.
- If there is a communication error between the
Display and Main Controller, the Convertible
Display light may blink. If the blinking continues for
a long period of time, please contact a Samsung
Electronics Service Center.
USING THE COLD WATER DISPENSER
Push the appropriate ice type button to
select what you want dispensed.
Using the ice Dispenser
Place a glass underneath the ice
dispenser and push gently against
the dispenser lever with your glass.
Make sure the glass is in line with
the dispenser to prevent the ice from bouncing out.
Please wait 2 seconds before removing the
glass under the dispenser to prevent spills.
If the Refrigerator door opens, the Dispenser does
not work.
• When Cubed Ice is selected after using
the Crushed Ice feature, a small amount of
residual crushed ice might be produced.
• After Water Dispenser Installation, press the
dispenser arm for at least 2 minutes to remove
trapped air from the water line and to fill the water
system.
Do not pull the lever out. You could damage
or break the
lever's spring.
• To clean
the ice bin/
bucket, wash
with a mild
detergent,
rinse well, and
dry thoroughly
it. Do not use
harsh or abrasive cleaners or solvents.
• If ice doesn’t come out, pull out the ice bucket
and press the test button located on the right
side of ice maker.
• Do not press the test button continuously when
the tray is filled with ice or water. Water may
overflow or ice may jam the bucket.
• Normal Use
To fill the ice bucket to maximum capacity after
installation, follow these steps:
1. Allow your refrigerator to operate and cool
down for 24 hours (or 1 full day).
- Waiting 24 hours will allow your ice maker to
cool properly.
2. Dispense 4 to 6 ice cubes into the glass.
3. After 8, and then 16 hours, dispense a full
glass of ice.
• When you press the Test button, you will
hear the refrigerator chime (ding-dong).
When the chime sounds, release the Test
button.
• The chime sounds automatically again to let you
know the ice maker is working well.
NO ICE
Select this if you want to
turn ice maker off
check the
water level
Test button
CAUTION
CAUTION
CAUTION
CAUTION
Recommend Temp (Fridge) : 38°F (or 3°C )
DA68-02481A-10.indb 15 13. 4. 25. �� 2:18