Samsung RF4267HARS Refrigerator User Manual


 
setting up _07
01 SETTING UP
7
8
9
2.
Disconnect one connector ( 3 ) on the right side door
and one connector ( 4 ) on left side door. To remove
the water coupler from the hinge, twist and pull it from
the hinge. Remove the water line ( 5 ) while pressing
the marked part ( 6 ) of the water line coupler.
If a red clip is on the coupler, it must be
removed before removing the tube.
3. Pull and remove the hinge lever ( 7 ) . Remove the
ground screw ( 8 ) attached to the upper left and
right door hinges with a philips screwdriver (+).
Remove the upper left and right door hinges ( 9 ).
4. Lift the door straight
up to remove.
5. Remove the screw ( 10 ) attached to the
lower left and right door hinges with a philips
screwdriver(+). Remove the 2 hex head bolts
( 11 ) attached to the lower left and right door
hinges with an allen wrench (3/16”). Remove the
lower left and right door hinges ( 12 ).
REATTACHING THE REFRIGERATOR DOORS
To reattach the fridge doors after you have moved the
fridge to its final location, assemble parts in reverse order.
1. The Water Line must be fully inserted to the center
of transparent coupler (Type A) or the line(Type B) to
prevent water leakage from the dispenser.
2. Insert the clip in the install pack and check that it
holds the line firmly.
DISASSEMBLE THE FLEX DOOR
1. Take out the Flex Zone
( 1 ) by lifting it up.
2. Take off the cover ( 2 )
w/harness with a flat-
blade screwdriver (-).
3.
Press the locking tab and separate the Wire Connector.
When reassembling it, be sure to connect
the wire harness. If it is not connected,
the Flex Room does not work.
4. Remove 2 hex head
bolts from sides with a
socket wrench (10mm).
5. Lift up the Flex door from
the rails.
1
2
CAUTION
CAUTION
4
5
6
3
Red Clip
(1/4")
Allen wrench
12
10
11
1
2
Center of Transparent coupler
The Guide Lines
Dispenser
clip A (1/4”)
(6.35 mm)
clip A (1/4”)
(6.35 mm)
Type A
Type B
DA68-02481A-10.indb 7 13. 4. 25. �� 2:18