Filter
Top Products
08_ setting up
ASSEMBLE THE FLEX DOOR
To reattach the flex doors after you have moved the
fridge to its final location, assemble parts in reverse order.
Be sure to connect the Flex Door Wire
Connector. If it is not connected, the Flex
Room does not work.
DISASSEMBLE THE FREEZER DRAWER
1. Take out the upper
drawer by lifting it
up.
2. Remove the freeze
room guard ( 1 ) by
lifting the guard up.
3. Take out the lower
basket ( 3 ) by lifting
the basket up from
the rail system.
4. Remove 4 hex head
bolts from both sides
with a socket wrench
(10mm).
5. Lift up the freezer door
from the rails.
Putting too much food into the freezer
drawers can prevent the freezer from
closing completely and can cause frost
build-up.
ASSEMBLE THE FREEZER DRAWER
To reattach the drawer after you have moved the fridge
to its final location, assemble parts in reverse order.
ADJUSTING THE LEVEL
Make sure the refrigerator is level so that you can
make final adjustments. Use a level to test if the
refigerator is level both side to side and back to front. If
the refrigerator is not level, it will not be possible to get
the doors perfectly even, which may cause moisture
condensation and increased energy bills. Below is an
example of how to level the refrigerator if the left side
of the refrigerator is lower than the right side.
How to adjust the level
Insert a flat-blade screwdriver (-) into a notch on the
left control lever, and turn it count clockwise to level
the refrigerator. (You turn the lever clockwise to lower
the refrigerator and counterclockwise to raise it.)
Both control levers must be touching the floor
to avoid possible personal injury or property
damage because of tipping.
If the right side is lower, perform the same
procedure, but with the right control lever.
It is difficult to remove the cover leg front from
the refrigerator, so we do not recommend
making small adjustments wIth the control lever.
Instead, refer to the next page for the best way
to make minor adjustments to the doors.
MAKING MINOR ADJUSTMENTS
BETWEEN DOORS
Remember, a leveled refrigerator is necessary for
getting the doors perfectly even. If you need help,
review the previous section on leveling the refrigerator.
1
3
flat-blade screwdriver(-) Control Lever
CAUTION
CAUTION
CAUTION
DA68-02481A-10.indb 8 13. 4. 25. �� 2:18