Filter
Top Products
32
INSTALLATION OF THE WATER DISPENSER LINE
1) As shown, open the cartridge cover by pulling and pushing up at the front
2)
Remove the water filter from the box then position the arrow of the cartridge in line with the cartridge cover.
3) Insert the filter as shown and Push until you hear a click.
4) Close the filter cartridge cover.
Install the water filter.
1) Slip the compression nut and plastic ferrule
through the plastic tube.
2) After inserting the sleeve, tighten the compres-
sion nut onto 1/4” compression fitting(union).
Connect the water line to the refrigerator.
Water line must be connected to drinkable water only.
Cut off 1/4 inch squarely to prevent leaks when reconnecting.
Do not overtighten the compression
nut.
NOTE
The water filter cartridge is located at the upper right corner of the Fridge compartment.
When the display in the control panel indicates “filter change”, it is recommended that the filter cartridge be changed.
NOTE
Under the high water pressure, water may drip from the water filter’s case.
If you put the small tray beneath the filter cover hole, it will be helpul to clean the shelf.
NOTE
Be sure to align the filter cartridge hook and housing.
NOTE
NOTE
After changing the filter cartridge, throw away the first six glassfuls of water to flush out trapped air.
Do not push and pull the water cartridge repeatedly, as water pressure will make the water spurt.
NOTE
3) Slip the compression ferrule and nut on cop-
per (or plastic) tubing as shown.
Tighten the compression nut onto the com-
pression fitting(union).
4) Turn water on and check for any leakage.
Compression Nut
Compression fitting
Sleeve
Compression Nut
Ferrule
Ferrule