Samsung RS261MDPN Refrigerator User Manual


 
 setting up
setting up your side-by-side refrigerator
SETTIN



Now that you have your new Refrigerator installed in place, you are ready to set up and enjoy the features and
functions of the appliance. By completing the following steps, your Refrigerator should be fully operational.
If not, first check the power supply and electricity source or try the troubleshooting section at the back of
thisuser’sguide.Ifyouhaveanyfurtherquestions,contactyourSamsungElectronicsservicecenter.
1. Place the Refrigerator in an appropriate location with reasonable clearance between the wall and the
Refrigerator. Refer to installation instructions in this manual.
2. Once the Refrigerator is plugged in, make sure the interior light comes on when you open the doors.
3. Set the Temperature control to the coldest temperature and wait for an hour. The Freezer will get slightly
chilled and the motor will run smoothly.
4. After powering the Refrigerator, it will take a few hours to reach the appropriate temperature. You can
store food and drinks in the Refrigerator after the temperature is sufficiently cool.
Check the accessory list below.
Installing the handles
 Take the handles out from the right side door.
The handles are included in the package.
 Check if the word “UP” on the rear of the handle is facing right side up.
LOCK
LOCK
Hex wrench Compression fitting Compression nut Clip Screw