Filter
Top Products
28_ operating
USING THE ICE MAKER
To Remove the Ice Bucket
- Hold the handle as shown in fi gure1.
- Slightly pull up the bottom part.
- Take out the ice bucket slowly.
To Refi t The Ice Bucket
- Assemble it in the reverse order of disassembly.
- Push the bucket in fi rmly until you hear a clicking sound.
- When the bucket does not fi t into its place, turn the gear handle on its back
by 90 degrees and reinstall it again as shown in fi gure 2.
Normal Operation
- Any sounds you hear when the ice maker dumps ice into the bucket are part
of normal operation.
- Not dispensing ice for long periods may cause ice clumps in the ice bucket.
Remove the remaining ice and empty the bucket.
- When ice does not come out, Check for any ice stuck in the chute and
remove it.
- The fi rst batch of ice cubes may be small due to air in the pipe after
connection, any air will be purged during normal use.
- When ICE OFF blinks on the display panel, reinsert the bucket and/or
make sure it’s installed properly.
- When the door is open, the Ice and water dispenser do not work.
- If you close the door hard, it may cause water spilling over the ice
maker.
- To prevent dropping the ice bucket, use both hands when removing it.
- To prevent injury, be sure to clean up any ice or water that may have
dropped on the fl oor.
- Do not let the children hang on the ice dispenser or on the bucket.
They may get hurt.
- Be sure not to put your hand or any object into the ice chute.
It may cause personal injury or damage mechanical parts.
Figure2
Ice Chute
Ice Chute
Figure1
CAUTION