Filter
Top Products
setting up
_07
01 SETTING UP
SETTING UP THE REFRIGERATOR
Now that you have your new Refrigerator installed in
place, you are ready to set up and enjoy the features
and functions of the appliance. By completing the
following steps, your Refrigerator should be fully
operational. If not, first check the power supply and
electricity source or try the troubleshooting section at
the back of this user’s guide. If you have any further
questions, contact your Samsung Electronics service
center.
1. Place the Refrigerator in an appropriate location
with reasonable clearance between the wall and
the Refrigerator. Refer to installation instructions in
this manual.
2. Once the Refrigerator is plugged in, make sure the
interior light comes on when you open the doors.
3. Set the Temperature control to the coldest
temperature and wait for an hour. The Freezer will
get slightly chilled and the motor will run smoothly.
4. After powering the Refrigerator, it will take a few
hours to reach the appropriate temperature. You
can store food and drinks in the Refrigerator after
the temperature is sufficiently cool.
SETTING UP THE REFRIGERATOR
DOORS
If your entrance won’t allow the refrigerator to pass
easily through it, you can remove the doors.
Separating the Water Supply Line from the
Refrigerator
1. Pull the two water lines (which are in the Fixer) out
to the front.
2. Remove two water lines (White one is for water
and the other one is for ice) by pressing the
coupler
1
and pulling the water line
2
away.
Removing the freezer door
A few things to mention first.
• Make sure that you lift the door straight up so the
hinges are not bent or broken.
• Be careful not to pinch the water tubing and wire
harness on the door.
• Place doors on a protected surface to prevent
scratching or damage.
1. Remove a screw on the upper hinge cover
1
.
With the door open, disengage the two locking
tabs with a flat-head screw driver
2
and remove
it while the lifting up the rear of the cover
3
, and
then disconnect the wires by gently pulling them
apart
4
.
2. Removing the FIXER HINGE ,and next take off the
upper hinge. Be careful that the door does not fall
on you as you are removing it.
Be sure to keep track of all parts you are
removing.
3. Next, remove the door from the lower hinge
5
by
carefully lifting the door straight up
6
.
Be careful not to pinch the water tubing and
wire harness on the door.
1
2
Make sure the color of
the water lines match.
4
3
2
1
6
5
DA68-02500B.indb 7 2012.6.7 1:39:49 PM