operating
_77
02 OPERATING
Removing residual matter inside the water
supply line after installing a new filter
1. Press the Water button, and then push the
Dispenser Lever with a cup or glass.
2. Flush 1 gallon of water through the filter, one
cup or glass at a time. (Flush approximately 6
minutes.) This will clean the water supply system
and remove air from the lines.
- Additional flushing may be required in some
households.
3. Open the refrigerator door and make sure there
are no water leaks coming from the water filter.
Reverse Osmosis Water Supply
IMPORTANT : The pressure of the water supply
coming out of a reverse osmosis system going to
the water inlet valve of the refrigerator needs to be
between 35 and 120 psi (241 and 827 kPa).
If a reverse osmosis water filtration system is
connected to your cold water supply, the water
pressure to the reverse osmosis system needs to be a
minimum of 40 to 60 psi (276 to 414 kPa.)
If the water pressure to the reverse osmosis system is
less than 40 to 60 psi (276 to 414 kPa):
• Check to see whether the sediment filter in the
reverse osmosis system is blocked. Replace the
filter if necessary.
• Allow the storage tank on the reverse osmosis
system to refill after heavy usage.
• If your refrigerator has a water filter, it may
further reduce the water pressure when used
in conjunction with a reverse osmosis system.
Remove the water filter.
If you have questions about your water pressure, call a
licensed, qualified plumber.
Ordering replacement filters
To order more water filter cartridges, contact your
authorized Samsung dealer.
TO IMPROVE THE COOLING
PERFORMANCE
If the cold air outlet is
blocked by food items,
the cold air cannot
penetrate the entire
compartment and will be
unable to freeze the food
efficiently which results
in a degraded cooling
performance.
In particular, there is load
limit at the top of the freezing
compartment. Please do not
put food items above this
limit.
Cold air outlet
Load limit in
the freezing
compartment
DA68-02500B.indb 77 2012.6.7 1:41:23 PM