INSTALLATION
Installation
1.
Remove the packaging materials and tapes Remove
all
transportation packaging materials and
tapes.
Open the doors and ventilate the unit. If the outside panels are dirty, clean them with a diluted
neutral
dishwashing detergent. (Undiluted detergent can damage the plastic components. For the
dilution, refer to the instruction of the detergent.) After
cleaning with the diluted detergent, always wipe
it
off with a wet cloth, then wipe the panels with a dry cloth.
2.
Door
handle installation
Remove the two plugs from the door where you will attach the door handle.
Apply
door handle, plastic washer and screw and fasten the screw. For floor-level installation the handle
should
be mounted at the higher location. For stacking above another compatible unit, the handle should be
mounted at the
lower location.
3.
Ground (earth)
~WARNING
Use a power
supply
outlet
with
ground
(earth) to prevent electric shock. If the power supply outlet
is
not
grounded,
qualified personnel must install a ground.
Never
ground
the
unit
through
a gas pipe,
water
main, telephone line
or
lightning
rod. Such
grounding may cause
electric shock
in
the case of
an
incomplete circuit.
START-UP OF UNIT
The following procedures should be adhered to for initial start-up and continuous operation.
1.
Connect the unit to dedicated power supply.
Do
not put any product
in
the unit at this time.
2.
Set the desired temperature.
3.
Confirm that the chamber temperature
is
at the desired temperature.
4. When
you
are satisfied that the unit
is
working correctly, begin slowly placing product into the chamber to
minimize the temperature rise.
5.
As this freezer's shelf is also
an
evaporator, the surface of the shelf will reach a much colder temperature
than the
displayed temperature. (The displayed temperature is the same as the air temperature inside
of
the
freezer).
Placing heat insulation material such as plastic between shelf and product
is
required if the
product's desired temperature
is
the freezer's displayed temperature.
12
English