Filter
Top Products
CAUTIONS FOR USAGE
1. If the unit is unplugged or the power to the unit is interrupted, do not restart the unit for at least 5 minutes.
This protects the compressor.
2. This inner cabinet is refrigerated by the forced circulation of cooled air inside the chamber. Ensure that
the intake and exhaust vents are not blocked. Adequate space should
be
provided between the items inside
the unit to allow air circulation.
3. Never store corrosive materials such as acid or alkali unless the container is completely sealed up.
Corrosion may lead to failure of the unit in time.
4. Once the chamber temperature has stabilized, put the items into the chamber in small batches to minimize
the temperature increase.
5. Place items
on
the shelves and leave a space between the walls of the cabinet and the contents to allow
air circulation.
6. Always close the door firmly. The door check lamp is lit when the door is open. The alarm buzzer
sounds after two minutes the door is kept open. The buzzer can
be
canceled automatically when the door is
closed.
7. Always open and close the door gently. Rough operation may lead to stored items falling down,
incomplete closing, or damage of door gasket.
8. Do not let items contact the wall.
9. If
an
instrument requiring a power source is to
be
placed inside the cabinet, the cable can
be
led through
the access port
on
the right side of the cabinet. After using the port, the rubber cap and insulation should be
replaced to seal the access port. Failure to do this
can
affect the temperature uniformity inside the cabinet
and lead to condensation
on
the outside of the access port.
10. Do not clean the unit with scrubbing brushes, acid, thinner, solvents powdered soap, cleanser or hot
water. These agents can scratch the paint or cause it to peel. Plastic and rubber parts can
be
easily
damaged by these materials. Especially never use any volatile solvent to clean the plastic or rubber parts.
When a neutral dishwashing detergent is used to clean the unit, wipe it up thoroughly with a cloth soaked in
clean water.
11. If condensation forms
on
the door or frame surface, wipe it off with a dry soft cloth.
12. The heat discharge pipe is attached inside of the both side & rear frame. The frame sometimes gets hot
at the start-up of the operation, but this does not mean that a malfunction has occurred.
7
English