Filter
Top Products
REMOVABLE OVEN DOOR
To remove:
1. Open the door to the stop position (see Illustrat[on),
2. Grasp the door at each side and lift up and off the
hinges,
NOTE: When the door is removed and
hinge arms are at stop position, do
not bump or try to move the hinge
arms. The hinges could snap back
causing an injury to the hands or
damage to the porcelain on the front
of the range. Cover the hinges with
toweling or empty towel roils while
working in the oven area,
To replace:
1. Hold the door over the hinges with the slots at the
bottom edge of the door lined up with the hinges.
The hinge arms must still be in the stop
position.
STOP {BR_
POSITION
HINGE
2. Slide the door down onto the hinges as far as it will
go and close the door°
REMOVABLE OVEN RACKS
Be careful not to scratch the oven finish when
installing or removing oven racks.
To install:
1. Set the raised back edge of the rack on a pairof rack
guides.
2. Push the rack in until you reach the bump in the rack
guide, then lift the front of the rack a bit and push the
rack all the way in.
To remove:
1, Pull the oven rack out, then up,
Some models have one standard oven rack and one
folding oven rack.
The folding rack can be conveniently stored away when
not in use°
Note: If oven racks are left in the range during a
clean cycle, they will darken, lose their luster
and become hard to slide, if you choose to leave
the racks in the oven, you can polish the edges
of the racks with steel wool and apply a small
amount of vegetable oil to the rack edges after
the self.clean cycle, This will make the racks
easier to slide.
16
NGMNT11