Sears 72678 Range User Manual


 
Oven Light Replacement
(on some models)
CAUTION: Before replacing your oven light bulb,
disconnect electrical power to the range at the main
fuse or circuit breaker panel. Be sure to let the light
cover and bulb cool completely.
Theovenlight(b b)is
covered with a removable
glass cover that is held in /_-."" I7_
place with a bail-shaped
wire_ Remove the oven
door, if desired, to reach i
the cover easily.
Wire cover holder
To remove:
1. Hold a hand under the cover so it doesn't fall
when released. With fingers of the same hand,
firmly push back the wire cover holder. Lift off
the cover. DO NOT REMOVE ANY SCREWS
TO REMOVE THE COVER.
2. Do not touch a hot bulb with a wet cloth. Replace
the bulb with a 40-watt household appliance bulb.
To replace cover:
I. Place it into the groove of the light receptacle. Pull
the wire forward to the center of the cover until it
snaps into place. When in place, the wire holds the
cover firmly, Be certain the wire is in the depression
in the center of the cover.
2. Connect electrical power to the range°
Lift-Off Oven Door
The oven door is removable,
but it is heavy. You may need
help removing and replacing
the door.
To remove the door, open it a
few inches to the special stop
position that will hold the
door open. Grasp firmly on
each side and lift the door
straight up and off the hinges.
NOTE: Be careful not to place hands between the
hinge and the oven door frame as the hinge could snap
back and pinch fingers.
To replace the door, make sure the hinges are in the
special stop position,, Position the slots in the bottom
of the door squarely over the hinges. Then lower the
door slowly and evenly over both hinges at the same
time. If the hinges snap back against the oven frame,
pull them back out.
TO CLEAN THE DOOR:
(Do not immerse the door in water°)
Inside of the door:
Because the area inside the gasket is cleaned during
the self-clean cycle, you do not need to clean this by
hand. Any soap left on the liner causes additional
stains when the oven is heated.
The area outside the gasket can be cleaned with a
scouring pad.
Do not rub or dean the door gasket--the
fiberglass material of the gasket has an extremely low
resistance to abrasion. An intact and well-fitting oven
door gasket is essential for energy-efficient oven
operation and good baking results. If you notice the
gasket becoming worn, frayed or damaged in any
way or if it has become displaced on the door, you
should have it replaced.
Inside gasket
gasket
Outside of the door:
Use soap and water to thoroughly clean the top, sides
and front of the oven door. Rinse well. You may also
use a glass cleaner to clean the glass on the outside of
the door.
Spillage of marinades, fruit juices, tomato sauces and
basting materials containing acids may" cause
discoloration and should be wiped up immediately.
When the surface is cool, clean and rinse.
" Do not use oven cleaners, deansLrlg powders or
harsh abrasives on the outside of the door.
(continued next page)
3I