Filter
Top Products
6
Cooktop Assembly
The burner rings spread the flame evenly around
the burner cap. All burner parts must be properly
seated for proper burner lighting and operation.
To assemble the burners:
Remove the burner rings, burner caps and 1.
grates from their shipping packages.
Install the burners as shown below. Gently twist 2.
each piece back and forth after installation to
make sure it is properly seated. A small gap
below the burner ring is normal when installed
properly.
Gently set the grates on top of the spill tray. Put 3.
the legs of each grate inside the corresponding
dimples.
Setting Up Your Range
Dual Burner Assembly
(left front burner only)
Standard Burner Assembly
(left rear, right front, right rear, burners)
STEP 1: Install dual
burner ring on dual
burner base. Line
up indentations on
bottom of burner ring
with pins on top of
burner base.
STEP 1: Install
standard burner
rings on standard
burner bases. Put
holes on edge of
each ring over
the igniter. Center
tabs on bottom of
each ring in hole
in center of each
base.
STEP 2: Set outer
dual burner cap on
dual burner ring. Make
sure it is centered on
top.
STEP 2: Install all
standard burner
caps. Ridge on
bottom of caps
must surround
top of ring.
STEP 3: Set inner
dual burner cap on
center of dual burner
base. Line up ridge
on bottom of cap
with pins on center of
burner base.
Inner burner cap
Ridge on bottom
Ridge on bottom
of burner cap
Outer burner cap
Burner ring
Pin on burner base
Igniter on burner base
Burner ring -
top view
Igniter hole