Sharp AR-5516N Oven User Manual


 
71
USER SETTINGS
5
*
1
When the RSPF is installed.
*
3
AR-5516N is as follows:
1: Upper tray (factory default),
2: 250-sheet paper feed unit/Upper paper tray of 2 x 250-sheet paper feed unit,
3: Lower paper tray of 2 x 250-sheet paper feed unit,
5: Bypass tray
24
Memory allocated to
printer mode
1: 30%
2: 40%
3: 50%
4: 60%
5: 70%
Use this to change the proportion of machine
memory used for printer mode.
25 Key auto repeat
0: OFF
1: ON
Use this setting to select whether or not
holding down a key causes repeated input of
the key. For keys that normally cause a set
value to increase when held down (for
example, holding down the [ZOOM] key (
,
)), this program can be used to have the
set value not change when the key is held
down.
26 Key press time
1: Minimum
(current response
speed)
2: 0.5 sec.
3: 1.0 sec.
4: 1.5 sec.
5: 2.0 sec.
Use this setting to select how long a key must
be pressed for the input to be accepted. By
selecting a longer time, you can prevent
settings from being changed by the accidental
pressing of a key.
27 Audible signals volume
1: Short beep
2: Long beep
3: OFF
This sets the volume of beep signals. (p.72)
28
Base setting beep
signal
0: OFF
1: ON
Use this to sound a beep when a base setting
is selected. (p.72)
29 Number of copies limit
1: 99 copies
2: 999 copies
Use this setting to select 99 or 999 for the
maximum number of copies.
30 Use close paper size
0: OFF
1: ON
When this function is enabled, printing in
printer mode will automatically continue using
a different size of paper if the specified size of
paper runs out in all trays. This feature does
not function in copy mode.
31 Default tray setting
*3
1: Upper paper tray
2: Lower paper tray
3: 250-sheet paper
feed unit/
Upper paper tray of 2
x 250-sheet paper
feed unit
4: Lower paper tray of 2
x 250-sheet paper
feed unit
5: Bypass tray
Use this program to select a default tray. This
tray is automatically selected each time the
power is turned on or each time the machine
reverts to the initial settings.
32
Default exposure
mode
1: AUTO
2: TEXT
3: PHOTO
Use this program to set "AUTO", "TEXT", or
"PHOTO" as the default exposure mode.
34 Sort auto select
*1
1: OFF
2: Sort
3: Group
Use this setting to select the default output
mode for copying from the RSPF.
Program
number
Program name
Setting codes
(factory default setting
appears in bold)
Explanation