Sharp AR-5516N Oven User Manual


 
87
TROUBLESHOOTING
6
Why can't I search the machine
using the configuration utility (Set
the IP Address)?
Check if there is any router or DHCP server that can assign IP
addresses automatically.
The automatic process may have assigned an IP address to
the machine with which the network communication cannot
be established with the computer.
Configure IP addresses in the same local environment
where the router or server does not exist when installing the
machine for the first time.
Check if there is any security software function such as
firewall in the computer.
The security software function may be interrupting network
communication with the machine. Disable the function to see if
the problem continues. For information on disabling the
function of the security software, refer to the manual or online
help of the software.
The network function of the machine has not activated yet.
It takes approximately 30 seconds to boot the network
function after powering on the machine. Wait 30 seconds and
try the configuration again.
There may be defective equipment
between the client computer
running the configuration utility
(Set the IP Address) and the
machine.
Check if the green LED (10/100 BASE networking) of the
machine is on (not blinking).
If a problem is observed, there may be a defective cable or
device. Change the power cable, network cable or the
connected device and see if the problem continues.
The machine and the client computer running the
configuration utility must be in the same segment.
Be sure to setup both in the same segment when installing the
machine in your environment for the first time.
Check if the computer running the configuration utility has an
IP address assigned.
Verify the computer's network setting via Network
properties, or using "ipconfig" command.
If the computer does not have an IP address, configure an
IP address.
The IP address of the machine and the client computer
running the configuration utility must be in the same segment.
Verify the computer's network setting via Network
properties, or using "ipconfig" command.
Be sure to assign an IP address for the machine and the
computer within a same segment.
Check if there is any router or DHCP server that can assign IP
addresses automatically.
The automatic process may have assigned an IP address to
the machine with which the network communication cannot
be established with the computer.
Configure IP addresses in the same local environment
where the router or server does not exist when installing the
machine for the first time.
The network settings of the machine are not the factory default.
Initialise the network settings of the machine to the factory
default and conduct the configuration.
103,
Start
Guide
Why does the installation of the
driver software hang?
Resident software on the computer may affect the installation
process.
Terminate unnecessary resident software.
Question Answer Page