Filter
Top Products
39
TROUBLESHOOTING CHART
The following situations are normal and are not signs that the oven is malfunctioning.
* Check that power plug is connected to a suitable wall
outlet. See page 4.
* Check that fuse or circuit breaker is functioning properly.
If not, correct.
* Disconnect the oven from the power source, wait one
minute and then plug into the wall outlet. If the problem
exists, consult a Sharp Authorized Servicer.
* Open the door and close. Is the oven light off? Press
START again.
* If the display says, "Wait. Oven is too warm to use.", be
sure to wait until it disappears and then press START.
The cooking program will be cancelled. Continue to cook
with manual operation. Check food carefully as it cooks.
Normal operation to prevent bread dough from drying on
the surface.
This is normal operation. See page 15.
Oven light will turn OFF if the door is open for more than 5
minutes.
Sleep Mode may be ON. Press any pad, turn the Dial or
open/close the door to activate display backlight. See page
35 to cancel Sleep Mode.
Control panel /
power supply
The display is black / blank.
The display is fine but START
will not function when pressed.
Electrical power supply is
interrupted during cooking.
Oven light is off during PROOF.
Oven light is off during
descaling.
Oven light is off when door is
opened.
The display backlight is off.
QUESTION / SITUATION ANSWER