Filter
Top Products
2
INSTALLATION MANUAL
• Provide adequate clearances between the appliance and adjacent
combustible surfaces.
• Dimensions that are shown in Figures 2 and 3 must be used.
Given dimensions provide minimum clearance. There needs
to be a 30-inch minimum clearance between the top of the
cooking surface and the bottom of upper unprotected wood or
metal cabinets or a 24-inch minimum when bottom of upper
wood or metal cabinets are protected by not less than a 1/4-inch
fl ame retardant millboard covered with not less than no. 29 msg
sheet-steel, 0.015-inch stainless steel, 0.024-inch aluminum or
0.020-inch copper. The gray shaded area in the lower part of
Figure 2 indicates the location for the electrical junction box.
• Contact surface must be solid and level. Pay special attention
to the countertop. Be sure it is solid enough for the weight of
the appliance.
• Check location where the appliance will be installed for proper
electrical supply.
Figure 2
Figure 1
30"
cutout
22 7/8"
cutout
3/8" minimun
flat area
31 1/2"
To eliminate the risk of burns or fi re by reaching over the
cooktop, cabinet storage space located above the cooktop should
be avoided. If cabinet storage is to be provided, the risk can be
reduced by installing a range hood that projects horizontally a
minimum of 5” beyond the bottom of the cabinets.
Figure 1 contains many appliance measurements for reference when
planning your kitchen and/or appliance location.
CLEARANCES AND DIMENSIONS APPLIANCE MEASUREMENTS
If using countertop with integrated
drip edge, remove 3/4” to clear
31 1/2” width control panel as
illustrated.
Figure 3
R
3/8" minimun
flat area
15"
auto
drawer open
31 1/2" glass and
control panel
29 7/8"
width of unit
30"
door and
louver width
23 7/16"
depth
1 11/16"
door thickness
15 5/8" from
the bottom side
of the cooktop
to the
bottom cover
36"
countertop
height
18"
to upper
cabinets
22 7/8"
6"
6"
Allow
7/16"
product
overlap
15" ±1/8"
vertical
opening
23 1/2"
min
depth
25"
countertop
depth
16 5/8"
min to any
obstruction
behind
cabinet face
30"
to bottom of
cabinet over
cooktop
30"
13"
max
30"
opening
width
Preferred
junction box
location
3/4" min.