Filter
Top Products
3
INSTALLATION MANUAL
IMPORTANT SAFETY INSTRUCTIONS
If the information in this manual is not followed
exactly, a fi re or electrical shock may result causing
property damage, personal injury or death.
• ALL APPLIANCES CAN TIP
• INJURY TO PERSONS COULD RESULT
• INSTALL ANTI-TIP BRACKET PACKED
WITH APPLIANCE
To reduce the risk of tipping the appliance, it
must be secured by the Anti-Tip bracket attached to the appliance.
See page 4 and page 6.
• This appliance must be electronically grounded in accordance
with local codes, or in their absence, with the National Electrical
Code ANSI/NFPA No. 70—latest edition in United States.
• The installation of appliances designed for manufactured
(mobile) home installation must conform with Manufactured
Home Construction and Safety Standard, title 24CFR, part
3280 [Formerly the Federal Standard for Mobile Home
Construction and Safety, title 24, HUD (part 280)] or when such
standard is not applicable, the Standard for Manufactured Home
Installation 1982 (Manufactured Home Sites, Communities and
Setups), ANSI Z225. 1/NFPA 501A- latest edition, or with local
codes in United States.
• Make sure the wall coverings and the cabinets around the
appliance can withstand the heat generated by the appliance.
Never leave children alone or unattended in the
area where an appliance is in use. As children grow, teach them
the proper, safe use of all appliances.
Stepping, leaning or sitting on the drawer of this
appliance can result in serious injuries and can also cause damage
to the appliance.
• Do not store items of interest to children in the cabinets
above the appliance. Children could be seriously burned
climbing on the appliance to reach items.
• To eliminate the need to reach over the cooktop, cabinet storage
space above the cooktop should be avoided.
• Do not use the drawer as a storage space. This creates a
potentially hazardous situation.
• Never use the appliance for warming or heating the
room.
• Do not store or use gasoline or other fl ammable vapors and
liquids near this or any other appliance. Explosions or fi res
could result.
• Reset all controls to the “off” position after using a
programmable timing operation.
IMPORTANT NOTES TO THE INSTALLER
• Read all of the Installation Manual before installing the
appliance.
• Remove all packing material from the drawer and cooktop
before connecting the electrical supply to the appliance.
• Observe all governing codes and ordinances.
• Be sure to leave these instructions with the consumer.
IMPORTANT NOTES TO THE CONSUMER
Keep this manual with your Operation Manual for future reference.
• As when using any appliance generating heat, there are certain
safety precautions you should follow. These are listed in the
Operation Manual. Read all and follow carefully.
• Be sure your appliance is installed and grounded properly by
a qualifi ed installer or service technician. See page 7.
• To eliminate the need to reach over the cooktop, cabinet storage
space above the cooktop should be avoided or a range hood
installed.
UNPACKING AND EXAMINING YOUR
APPLIANCE
1 Remove all packing
materials from inside
the Microwave Drawer.
DO NOT REMOVE
THE WAVEGUIDE
COVER, which is
located on the top of
the Microwave Drawer
cavity.
2 Remove the feature
sticker, if there is one.
Check the drawer for
any damage, such as
misaligned or bent
drawer, damaged
drawer seals and sealing surfaces, broken or loose drawer guides
and dents inside the drawer or on the front side of the drawer. If
there is any damage, do not operate the Microwave Drawer and
contact your dealer or a SHARP AUTHORIZED SERVICER.
IMPORTANT
Do not lift or move this appliance by the Micro-
wave Drawer handle.
Sealing
Surface
Microwave
Drawer
Cavity
Waveguide
Cover
Sealing
Surface