Sharp Electric Rang Range User Manual


 
2
36"
countertop
height
18"
to upper
cabinets
23
1
/8"
minimum 30"
to bottom of
cabinet over
cooktop
30"
30"
opening width
Maximum
depth of cord,
plug and
receptacle box
is 4" to prevent
interference
with lower
oven.
preferred electrical
outlet area
6
1
/8"
6
1
/8"
7
3
/8"
4"
6"
6"
INSTALLATION MANUAL
27"
back to front
of doors
45
3
/8"
oven door
open
42"
drawer
open
36"
to bottom
of cooktop
surface
31
1
/4"
glass and
control panel
29
7
/8"
width of unit
30"
door width
Provide adequate clearances between the range and adjacent
combustible surfaces.
Dimensions that are shown in Figure 2 must be used. Given
dimensions provide minimum clearance. There needs to be a
30-inch minimum clearance between the top of the cooking
surface and the bottom of unprotected wood or metal cabinets or
a 24-inch minimum when bottom of wood or metal cabinets are
protected by not less than a
1
/4-inch ame retardant millboard
covered with not less than no. 29 msg sheet-steel, 0.015-inch
stainless steel, 0.024-inch aluminum or 0.020-inch copper. Note
that the gray shaded area on Figure 2 indicates the location for
the electrical receptacle/connection.
Contact surface must be solid and level. Pay special attention
to the oor. Be sure it is solid enough for the weight of the
range. Check that the oor covering is smooth and at and that
it adheres to the sub-oor solidly.
Check location where the range will be installed for proper
electrical supply.
Figure 2
Figure 1
30"
cutout
23 1/8" cutout
1/2" minimun
flat area
31 1/4"
To eliminate the risk of burns or re by reaching over the
cooktop, cabinet storage space located above the cooktop should
be avoided. If cabinet storage is to be provided, the risk can be
reduced by installing a range hood that projects horizontally a
minimum of 5" beyond the bottom of the cabinets.
Figure 1 contains many range measurements for reference when
planning your kitchen and/or range location.
ClEaRanCEs anD DIMEnsIons
RanGE MEasuREMEnts
If using countertop with integrated
drip edge, remove 5/8" to make
flush as illustrated.
Figure 3
5/8" min.