Filter
Top Products
8
U N P A C K I N G A N D I N S T A L L A T I O N I N S T R U C T I O N S
5 TOOLS RECOMMENDED FOR INSTALLATION
• Phillips Screwdriver
• Electric Drill
• 1/2”, 5/8” and 3/32” Drill Bits
• 1-1/2” Wood Bit or Metal Hole Cutter
(if metal cabinet is used)
• Saw to cut exhaust opening (if needed)
6 INSTALLATION HARDWARE
The INSTALLATION HARDWARE items 1 - 5 are in a small bag. Items 6 - 9 are packed separately. All items
are in a small carton packed below the oven.
ITEM NAME QUANTITY PART CODE
1
Wood Screw 5 X 30 mm 4 XTSS750P35000
2
Toggle Bolt with nuts #10 - 24 x 50 mm
4 LX-BZ0195WRE0
3
Top Cabinet Screw 5 X 85 mm 2 XBPS750P85000
4
Tapping Screw 4 x 12 mm 1 XOTS740P12000
5
Flat Washer 30 mm diameter 2 XWH750-16300
6
Rear Cushion 1 PCUSUB059MRP0
7
Exhaust Damper Assembly
1 FFTA-B005MRK0
8
Scale Plate 2 LANG-B002MRP0
9
Grease Filter 2 PFIL-B002MRE0
Figure 4
Parts shown not
to common scale.
• Protective Drop Cloth for product and range
- you may also use carton for protection
• Scissors
• Pencil
• Measure
• Tape
7 PREPARATION OF THE OVEN
Seperate mounting plate from oven by removing two screws.
See illustration below. Save these screws for use in section
11 MOUNTING OVEN TO WALL, step 5.
BACK OF MICROWAVE
MOUNTING
PLATE
318-3_1405,06 manual.indd 8 5/14/07 2:14:00 PM