Filter
Top Products
5
Figure 11
Wire Box
C. VERTICAL EXHAUST: Outside Ventilation
1
. Remove and save the 4 screws from the Fan Cover Bracket. Remove Fan
Cover Bracket by sliding it in the opposite direction of the arrow on the Fan
Cover Bracket as shown in Figure 13.
2. Lift the Hood Fan Unit carefully and slip wires out of cavity. See Figure 14.
CAUTION: Do not pull or stretch hood fan wiring.
3. Rotate the Hood Fan Unit 180˚ so that the fan blade openings are facing
the back of the oven. Note, you will need to lift the wire over the hood fan
unit so the wire will clear. See Figure 15 (A). Then rotate the Hood Fan
Unit 90˚ so that the fan blade openings are facing the top of the oven. See
Figure 15 (B). Replace Hood Fan Unit into the oven. Be careful not to
pinch the lead wire between the inner bracket and the Hood Fan Unit. Put
the lead wire into Wire Box. See Figure 15 (C).
4. Replace the Fan Cover Bracket. Make sure the fan blades are visible
through the top openings in the oven before proceeding.
5. Attach the Fan Cover Bracket to unit with the 4 screws removed in step 1
above. See Figure 16. The Hood Fan Unit is now rotated for vertical
exhaust operation.
6. Attach the Exhaust Damper Assembly to the fan cover on the top of the
outercase cabinet by sliding it into the slits in the same direction as the
arrow. Use 1 Tapping Screw 4 X12 mm from the INSTALLATION HARD-
WARE and tighten into place. See Figure 17.
Exhaust Damper
Assembly
Figure 17
Mounting Plate
(Back side)
Figure 12
Fan Cover Bracket
Figure 13
Figure 14
Figure 15
Figure 16
Wire Box
(B)
(A) Rotate 180˚
(C)