Sharp TINSKB147MRR1 Microwave Oven User Manual


  Open as PDF
of 4
 
E 2
B
C
D
E
F
G
H
I
I
J
K
L
M
N
O
P
Q
A
CLEARANCES ANd dImENSIoNS
Dimensions that are shown in Figure 1 (for 24") or Figures
3 and 4 (for 30") must be used. Given dimensions provide
minimum clearance. Locate electrical outlet in the shaded
area in the upper left-hand corner of the cutout. See Figure 7.
Contact surface must be solid and level. Pay special attention
totheooronwhichtheMicrowaveDrawerwillsit.The
ooroftheopeningshouldbeconstructedofplywood
strong enough to support the weight of the oven (about 100
pounds).
Check location where the Microwave Drawer will be
installed for proper electrical supply.
• Yourovencanbebuiltintoacabinetorwallbyitselfor
under a gas or electric wall oven.
• Besur
ethattheclearanceoftheoorbetweenthewalloven
and the microwave drawer is a minimum of 2-inches.
The microwave interior will easily accommodate a 9" x 13"
oblong dish or a bag of microwave popcorn.
24" mICRoWAvE dRAWER mEASUREmENtS


Figures 1 and 2 contain many Microwave Drawer measurements
for reference when planning the drawer’s location.
This Microwave Drawer can be installed below any electric or
gas wall oven.
* Can also be installed using an electrical outlet in an adjacent cabinet
within the area where the provided electrical cord can reach. Power
cord access hole in cabinet should be a minimum 1
1
/2" diameter
hole and deburred of all sharp edges.
IMPORTANT
Always allow sufcient power cord length to the
electrical outlet to prevent tension.
Always check electrical codes for requirements.
A
B
C
D
E
F
G
H
I
J
A. 6" (152.40 mm)
B. Suggested electrical outlet location*
C. Anti-Tip block
D. 5" (127 mm)
E. 3-1/2" (88.90 mm)
F. 4" (101.60 mm)
G. 22-1/8" (561.98 mm) opening
H. 14-13/16" (376.24 mm) to bottom of Anti-Tip block
I. Allow 7/8" (22.23 mm) overlap
J. 23-1/2" (596.90 mm) minimum depth
K. Allow 3/16" (4.76 mm) overlap
L. 36" (914.4 mm) countertop height
M. Allow 7/16" (11.11 mm) overlap
N. Floor must support 100 lb (45.4 kg)
O.19"(482.60mm)totopofoor
P. 24" (609.6 mm) cabinet minimum
Q. 14-13/16" (376.24 mm) opening
A. 21-5/8" (549.28 mm)
B. 4-11/16" (119.06 mm)
C. 1-3/4" (44.45 mm)
D. 21-7/8" (555.60 mm)
E. 23-7/8" (606.43 mm)
F. 15" (381 mm)
G. 14-19/32" (370.69 mm)
H. 1-11/16" (42.86 mm) door thickness
I. 15" (381 mm) auto drawer opening
J. 4" (101.6 mm)
 previous next