Sharp TINSKB147MRR1 Microwave Oven User Manual


  Open as PDF
of 4
 
E 4
Mounting
flange
dRAWER INStALLAtIoN
1. Place the drawer adjacent to the wall or
cabinet opening. Plug the power supply cord
into the electrical outlet.
2. Carefully guide the drawer into the prepared
opening. Avoid pinching the cord between
the oven and the wall.
3. Slide the drawer all the way until the
mountingangeisushwiththefaceofthecabinet.See
Figure 8A.
4. Open the drawer. Using the 4 holes on the drawer as a template,
pre drill the cabinet using a 1/16" bit. See Figure 8A.
5. Secure the drawer with the 4 screws supplied. See Figure 8B.
modEL ANd SERIAL NUmBER LoCAtIoN
The name plate includes model and serial number. Open the
Microwave Drawer fully. The label is beyond the back wall of
themicrowavecavityfacingupfromtheatsurface.
CARE, CLEANING ANd mAINtENANCE
Refer to the Operation Manual for cleaning instructions.
BEfoRE yoU CALL foR SERvICE
ReadtheBEFOREYOUCALLandoperatinginstructionsections
in your Operation Manual. It may save you time and expense.
The list includes common occurrences that are not the result of
defective workmanship or materials in this appliance.
Refer to the warranty in your Operation Manual for Sharp’s
service number and address. Please call or write if you have
inquiries about your microwave product and/or need to order
parts.

ELECtRICAL oUtLEt
4"
(101.6 mm)
5" (127 mm)
6"
(152.4 mm)
3 1/2"
(89 mm)
Suggested electrical
outlet location*
Anti-Tip block
The electrical requirements are a 120 volt 60 Hz, AC only,
15 amp. or more protected electrical supply. It is recommended
that a separate circuit serving only this appliance be provided.
The drawer is equipped with a 3-prong grounding plug. It must
be plugged into a wall receptacle that is properly installed and
grounded.Shouldyouonlyhavea2-prongoutlet,haveaqualied
electrician install a correct wall receptacle.
Note: If you have any questions about the grounding or electrical
instructions,consultaqualiedelectricianorserviceperson.
* Can also be installed using an electrical outlet in an adjacent cabinet
within the area where the provided electrical cord can reach.
Always check electrical codes for requirements.
GRoUNdING INStRUCtIoNS
This appliance must be grounded. The Microwave Drawer is
equipped with a cord having a grounding wire with a grounding
plug. It must be plugged into a wall receptacle that is properly
installed and grounded in accordance with the National
Electrical Code and local codes
and ordinances. In the event of
an electrical short circuit,
grounding reduces risk of
electric shock by providing an
escape wire for the electric
current.
– Improper use
of the grounding plug can result
in a risk of electric shock. Do
not use an extension cord. If
the power supply cord is too short, have a qualied electrician
or serviceman install an outlet near the appliance.

3-Prong plug
Grounding pin
3-Prong receptacle
Grounded receptacle box
Grounding adapter
Grounded receptacle box
Screw
Tab for grounding screw
4 Screws
Parts supplied


335 Britannia Road East • Mississauga, Ontario • L4Z 1W9
 previous