Filter
Top Products
Instructions for the user
- When the end of the cooking time is reached, the timer will switch off the
oven heating elements, the beeps will start and the numbers on the dial
will flash.
- The cooking time can also be reset by deleting the program set;
pressing the central key
for 1 or 2 seconds will delete the time set
and the oven will have to be switched off by hand.
Caution: cooking times of more than 6 hours cannot be set.
Cooking start: as well as setting a cooking duration time, the user can also
set the cooking start time (up to 12 hours after the current time). To set the
cooking start/end time, proceed as follows.
- Set the cooking duration time as described in the previous point.
- Within 6/7 seconds after the last time the
or keys are pressed,
press the
key to set the cooking start time. The display will show the
current time with the inside segments indicating the cooking end time
illuminated. Use the
and keys to set the cooking start time.
- 6/7 seconds after the last time a key is pressed, the display will show
the current time and the cooking start and end times, indicated by the
illuminated inside segments. The segments on the display will be
constantly on until the current time is the same as the cooking start time;
as soon as the current time reaches the cooking start time set, all the
inside segments will start to flash, indicating that the oven has started
cooking.
- When the end of the cooking time is reached, the timer will switch off the
oven heating elements, the beeps will start and the numbers on the dial
will flash.
- To reset the entire program set, keep the central key
pressed for 1
or 2 seconds: if cooking has already started the oven will have to be
switched off by hand.
- The image on the right shows an example of
programming: the current time is 7.06 and
cooking is programmed to start at 8 o'clock and
finish at 9.
- At 8 o'clock, the inside segments between 8 and
9 will start to flash and the hour pointer will
remain still.
Caution: for the oven to start cooking after the programming procedure
just described, the thermostat and function selector must be properly
set on the temperature and function required.
5.2.4 "DEMO" Function
Models with analogue/digital programmer feature a "DEMO" function which
deactivates the heating elements while leaving the other functions unchanged.
To activate it, simply press the
, and keys for 3/4 seconds. A
confirmation beep will inform the user that the function is active. To deactivate
it, simply repeat the same procedure.
49