Instructions for the User
32
above, or at the program temperature for cooking operations at below
100°C. After 20 minutes, the oven switches off.
N.B. - during preheating and cooking, whenever the door is opened the
message "door" will appear on the display and a beep will sound to warn
the user that the door must be closed while these operations are in
progress.
4.8 Modifying a previously edited program
To modify one of the programs, turn the knob to one of the programs from
P1 to P14 edited previously.
The parameters saved earlier will appear on the display.
Hold down STOP for 2 seconds.
The display shows U t°C.
Press START to display the cooking temperature.
Press START or keep it pressed to increase the cooking temperature;
each time START is pressed the temperature increments by 1°C (from 50°
to 300°), or hold START down for increments of 5°C.
Press STOP to move on to displaying the next parameter
The display shows U Ct.
Press START to display the cooking time.
Press START or keep it pressed to increase the cooking time (from 1 min.
to 99 min.).
Press STOP to move on to displaying the next parameter
The display shows U Ht only if Ut°C is set > 150°C
Press START to display the humidification cycles.
Press START or keep it pressed to increase the number of humidification
cycles (from 0 to 6 cycles where 0 means conventional fan-mode cooking
without the aid of humidification).
Press STOP to complete the program editing procedure.
The display shows UEnd.
The parameters set are now saved in the chosen program.
4.9 Manual cooking
Use the knob to select the manual program.
The special feature of this user-editable program is that the cooking
parameters set are not retained in the memory when the knob is turned to
any other position.
This means that an "empty" program is always immediately available for
quick, easy editing.