Filter
Top Products
Instructions for the installer
2. INSTALLATION OF THE OVEN
The oven must be set up on a perfectly flat surface and left standing
free. Make sure to allow enough room at the back for easy access to the
terminal strip for connection of the power cable to mains.
Installation must be carried out by a qualified technician in compliance
with applicable regulations in force.
Keep the appliance at least 5 cm from any walls at the sides and back.
2.1 Electrical connection
Make sure that the power line voltage matches the specifications
indicated on the rating plate located to the rear of the oven. This rating
plate must never be removed.
The oven is supplied complete
with a H07RN-F three-core
supply cable for operation from a
220-240V∼ power supply.
For operation from a 380-
415V2N∼ or 380-415V3N∼ power
supply, the original cable must
be replaced and the terminal
board connections modified
accordingly. For access to the
terminal board, remove the door
located at the back of the oven.
The standard cable is of the three-core 3 x
4 mm
2
H07RN-F type.
For operation from a 380-415V2N
∼
o 380-
415V3N
∼
power supply, replace the standard
cable with one of the H07RN-F type. The
cross section of the leads of the latter cable
must not be less than 2.5-1.5 mm
2
(4 x 2.5
mm
2
- 5 x 1.5 mm
2
); the ground (yellow-
g
reen)
of the termination to be linked up to the oven
must be at least 20 mm longer.
17