Filter
Top Products
Instructions for the installer
2. INSTALLATION OF THE OVEN
The oven must be set up on a perfectly flat surface and left standing
free. Make sure to allow enough room at the back for easy access to the
terminal block for connection of the power cable to the mains.
Installation must be carried out by a qualified technician in compliance
with the applicable CEE regulations in force.
2.1 Electrical connection
Make sure that the power line voltage matches the specifications
indicated on the rating plate located to the rear of the oven. This rating
plate must never be removed.
The oven is fitted with a H07RN-F three-core cable for operation at
230V~ and a power supply plug.
The standard cable is of the three-core 3 x 1.5 mm
2
H07RN-F type.
If necessary, the power lead must be changed by the manufacturer or by
an authorised service centre to prevent any risks.
Make sure that plug and wall socket are of the same type and are in
conformity with CEI regulations in force. Also check that the power
supply line is provided with an adequate ground plant. Avoid using
adapters or shunts.
2.1.1 Safety thermostat
The oven is fitted with a safety device which trips in case of serious
malfunction. To reset, contact the nearest service centre.
The manufacturer declines all liability for damage to persons or things
caused by non-observance of the above prescriptions or by tampering
with any part of the oven.
21