Filter
Top Products
Instructions for the User
108
12.9 Programming the automatic cleaning cycle
Turn the function selector knob to the symbol to start the pyrolysis cycle. The orange thermostat light
comes on, followed a few minutes later by the red "door interlock" light to indicate that the appliance's
door has been locked because of the high temperature inside. As soon as the function selector knob is
turned to , the display shows to indicate that the pyrolysis cycle will start immediately and will
last an hour and a half. The duration of the pyrolysis cycle can be increased up to a maximum of 3 hours.
To do this, after the pyrolysis cycle starts press the key followed within a few seconds by the value
variation keys or . A few seconds after the last key is pressed, the display will show the letter P
followed by the pyrolysis duration just set, and the letter A will stop flashing. After starting the pyrolysis
procedure, and modifying its duration as just described if required, the cleaning cycle end time can also
be programmed.
Press the key. The letter A will flash on the display, which will also show the sum of the current time
plus the duration of the pyrolysis cycle (e.g.: current time: 12.10 - programmed duration: 2.00 - figure
shown: 14.10). At this point, press the value variation keys or to program the cleaning cycle end
time. A few seconds after the last key is pressed, the display will show the current time and the orange
light will go out; it will come back on at the present time.
Warning: do not leave anything in the oven during the pyrolysis cycle. Keep children at a safe distance.
Take care above all when the start of the cycle is set with a delay from the current time.
Use of the hob is not permitted during the pyrolysis cycle.