Filter
Top Products
Instructions for the User
39
10.USING THE MAIN OVEN
10.1 First use
At first use, or after a power failure, the oven's display will show a flashing symbol. To be able to
start any cooking function with the main oven, the current time must be set.
10.2 Setting the current time
To adjust the current time with the flashing display:
• Press the buttons or to decrease or increase the time shown. If the button is held down in
one direction the time changes faster.
• When any button is released, after a few seconds the display will stop flashing and only the colon
separating the hour and minutes will flash to indicate its correct operation (The symbol will be
shown on the display).
It might become necessary to change the current time, for example at the switch from summer to winter
time.
hold down the button for a few seconds until the symbol stops flashing.
Repeat the operations described in point “10.2 Setting the current time”.
10.2.1Using the minute minder
The minute minder can be used during cooking or when the oven is turned off. The setting procedure is
the same for both cases.
Press the button briefly, the symbol will flash and the display will show the symbol (or the
time remaining from a previously programmed count).
Press the buttons
or to increase or decrease the minute minder time from 00:01 to 03:59 (hold
the button down to go faster). After a few seconds the count will begin and the remaining time and the
steady symbol will appear on the display.
To reset the minute minder, press the and buttons at the same time for approximately one
second.
Warning: The minute minder does not stop the cooking but rather informs the user when the set time has
run out. To turn off the oven, turn the PT2 knob to the O position.
Modifying the programmed data:
Once the count has begun, the previously set data can be modified. Repeat the operations described in
point “10.2.1 Using the minute minder”.
10.3 Selecting a function in manual cooking
A cooking function can be selected by simply turning PT2 to the right or left to the desired function. After
having selected the cooking function, use the PT1 knob to select the desired temperature.
Cooking is preceded by a preheating stage, which allows the oven to heat to the cooking temperature
more quickly. The symbol flashes on the display to indicate that this stage is in progress. When the
preheating stage is over, the symbol will remain on and a buzzer will sound to indicate that the food
can be placed inside the oven.