Filter
Top Products
GB-IE
Instructions for the Installer
17
17
10 INSTALLATION INSTRUCTIONS
10.1 Before installation
Check that the input voltage indicated on the characteristics plate is the
same as the voltage of the power outlet you are going to use.
Open the drawer and take out all the accessories and remove the
packing material.
Attention! The front surface of the warming drawer may be wrapped in a
protective film. Before using the warming drawer for the first time,
remove this film carefully.
Make sure that the warming drawer is not damaged in any way. Check
that the drawer opens and closes correctly. If you find any damage,
contact the Technical Assistance Service.
The warming drawer should only be built-in in combination with those
appliances indicated by the manufacturer. If it is fitted in combination
with other appliances, the guarantee is no longer valid since it is
impossible to guarantee that the warming drawer will work correctly.
10.2 Installation
To build-in the warming drawer in combination with another appliance
there must be a fixed, interim shelf in the housing unit to support the
weight of both appliances.
The appliance to be combined with the warming drawer will be placed
directly on the latter without any need to have a separating shelf.
To build-in the appliance which is combined with the warming drawer,
follow the instructions set out in the respective instructions and fitting
booklet.
The relevant installation dimensions are indicated in mm in the
installation diagram. Proceed as follows:
1. Place the warming drawer on the shelf and slide it towards the interior
of the niche in such a way that it is centred and completely lined up with
the front of the unit.
2. Check that the warming drawer’s frame is properly levelled and is sitting
evenly on the shelf.
3. Open the drawer and fix the warming drawer to the sides of the unit
using the two screws provided.