Filter
Top Products
GB-IE
Instructions for the Installer
1818
10.3 Electrical connection
Electrical installation must be performed by an electrician qualified in
accordance with the legislation in force.
Before connecting the warming drawer to the electric mains, check that
the voltage and frequency of the mains matches that which is shown on
the rating plate located in the heating block inside, which should be kept
together with this manual.
The electric connection is made via an omnipolar switch, which is suitable
for the intensity to be tolerated and which has a minimum gap of 3mm
between its contacts, which will ensure disconnection in case of
emergency or when cleaning the warming drawer. If a plug is used for the
electric connection, then it must be accessible after installation.
The connection should include correct earthing, in compliance with current
norms.
WARNING: THE WARMING DRAWER MUST BE EARTHED.
If the flexible supply cable fitted to the warming drawer ever needs to be
changed, it should be replaced by an official After Sales Service.
The manufacturer and retailers do not accept responsibility for any
damage that may be caused to people, animals or property if these
installation instructions are not observed.