Filter
Top Products
2
GB
Thank you for purchasing your new freezer
from Smeg. Please note that these instruc-
tions apply to all freezers in the SW range.
Illustrations and ttings may therefore not
necessarily correspond exactly to your
model.
Warning
As the refrigerant used in this appliance is a
ammable gas (Isobutane R600a), special
care must be taken to prevent damage
to the refrigerant circuit and piping during
transport and installation.
If damage does occur, avoid sparks or
naked ame in the vicinity of the appliance,
ensure that the room is well ventilated,
disconnect the power supply, and contact
your supplier.
The unit must only be serviced by quali-
ed technicians from an approved service
centre.
Old appliances
Old refrigerators and freezers are often
tted with complicated latches that can
only be opened from the outside. If you
have one of these old units stored away
somewhere, or if you scrap one, remember
to destroy the latch rst in order to prevent
children from being exposed to great dan-
ger by getting locked inside the unit.
Before use
Before operating your new appliance,
please read the following instructions care-
fully as they contain important information
on safety, installation, operation and main-
tenance. Keep the instructions for future
reference.
On receipt, check to ensure that the appli-
ance has not been damaged during trans-
port. Transport damage should be reported
to the local distributor before the appliance
is put to use.
Remove the packaging. Clean the inside of
the cabinet using warm water with a mild
detergent. Rinse with clean water and dry
thoroughly (see cleaning instructions). Use
a soft cloth.
If during transport the appliance has been
laid down, or if it has been stored in cold
surroundings (colder than +5°C), it must be
allowed to stabilise in an upright position for
at least an hour before being switched on.
Contents
Get to know your freezer..................3
Installation and start-up....................4
Reversing the door(s).......................7
Electrical connection.........................8
Operation and function.....................9
Use.................................................10
Defrosting........................................11
Cleaning and maintenance.............12
Fault nding....................................13
Spare parts and service..................14
Disposal..........................................15