Filter
Top Products
7
GB
The door(s) can be changed from right-hinged to left-hinged and vice versa as follows:
Reversing the door(s)
1. Lay the appliance on its back with the
door uppermost.
2. Remove the upper hinge.
3. Move the plastic plugs to where the
upper hinge was tted.
4. Lift off the door and lay it aside.
10. Remember to pull the pin in the door
closer towards the side before tting
the door..
6. Loosen lock nut with the fork wrench
enclosed and move the pin.
11. Ret the door.
12. Fit the upper hinge.
9. Remove the door closer and ret it on
the opposite side.
5. Remove the kick plate by pulling it
outwards and upwards.
7. Remove the lower hinge. Rotate the
hinge through 180° and ret it on the
opposite side of the appliance.
8. Ret the kick plate
15. After reversing the door(s), it is important to check that the sealing strip provides a tight seal all the way round. If it does not, carefully
heat the strip all the way round using a hair dryer. Then ease the strip outwards slightly so that it forms a tight seal against the cabinet.
Be careful not to heat the strip so much that it melts!
13. Remove the door handle and ret it on
the opposite side. Ret the caps.
14. The appliance must be allowed to
stabilise in an upright position for at
least 1 hour before being switched on.