Smeg DF410SF Dishwasher User Manual


 
User instructions
32
CLEANING THE FILTER UNIT
The central filter
H
should be inspected regularly and cleaned if necessary. To remove it, take
hold of the handle, turn anti-clockwise and lift.
Press the central filter
H
from below to extract it from the micro-filter.
Separate the two parts of the plastic filter by pressing the body of the filter in the zone shown
by the arrows.
Remove the central filter by lifting it.
GENERAL WARNINGS AND RECOMMENDATIONS FOR CORRECT MAINTENANCE:
The filters should be cleaned
under running water
using a stiff brush.
It is essential to
thoroughly clean the filters
according to the above instructions: the
dishwasher cannot function if the filters are clogged.
Carefully replace
the filters in their seats, to avoid damaging the wash pump.
PROLONGED DISUSE:
Run the soak program twice in succession.
Unplug
the power cord from the socket.
Leave the door slightly open
, in order to prevent the formation of unpleasant odours inside
the washing tank.
Fill the rinse aid dispenser
.
Shut off the water supply tap.
BEFORE STARTING THE DISHWASHER AFTER PROLONGED DISUSE:
Check that there are no deposits of sludge or rust inside the water pipe: if there are, allow the
water to run from the water supply tap for a few minutes.
Plug the power cord
back into the socket.
Reconnect the water intake hose and open the tap again.