Filter
Top Products
User instructions
PROGRAMMING
In this dishwasher model all the programming operations are possible
only with closed door. With open door, on the
DISPLAY (8)
will appear
the symbols
--
and the
PILOT LIGHT PROGRAMS (7)
remains out.
SELECTION PROGRAM
The program selection is possible
through the relative buttons
(2)
.
By pressing the relative button of desired program (see table) it will lid up
the relative pilot light to confirm that the operation did occurred on the
DISPLAY (8)
will appear a program duration forecasting (“
h.mm
”).
START PROGRAM
At this point, in order to start the machine, it is only enough to press the
START/STOP (5)
for some seconds until the writtin “
Time to end
” start
to flash and confirmation “beep” is heard. From this moment the cycle
dration on the
DISPLAY (8)
starts to decrease.
This phase, that updates itself during the cycle, is “indicative” since it is
influenced by the washing conditions such as dishwasher type and
quantity, entry temperature etc. For this reason it is normal to see the
updating during a program (increment and decrease of minutes)
specially in the passage from one phase to the other (for example, from
washing to rinse).
END PROGRAM
The end of the program is indicated by a short signal acoustic and from
the “
End
” visual notification on
DISPLAY (8)
. By pressing one of the
buttons, the “
End
” visual signal will vanish from the display and the
dishwasher is ready to continue a new cycle, the same thing happens
when closing or opening the door or by switching on-off the machine.