Filter
Top Products
User instructions
INTERRUPTION A PROGRAM
To interrupt a program in progress:
•
press the
START/PAUSE
button
(2)
; the light of the program in
progress remains on (confirmation beep);
•
you may now restart the program by pressing button
(2)
again until it
restarts, or change or annul the program (see "
C
HANGING A
PROGRAM
", or "
A
NNULLING A PROGRAM
").
CHANGING A PROGRAM
To change the running program it is necessary:
•
to interrupt the running program (see “
I
NTERRUPTION A PROGRAM
”);
•
select the new program;
•
start the program (see “
S
TARTING THE PROGRAM
”).
ANNULLING A PROGRAM
To annul the program, keep the
START/PAUSE
button
(2)
pressed until
the program is interrupted (light on and confirmation beep).
Press button
(2)
again and keep it
pressed until the
lights 4
and
5
(marked
"end") come on.
The water in the tank will be pumped out and the program will end at the
point where it was interrupted.
In case that the door is opened during the operation, to the next door
closing it is going to be necessary to start the program as shown in
paragraph “
S
TARTING THE PROGRAM
”. The program will resume from the
point in which it was interrupted.
In case that the tub temperature is higher than 50°C the program
will start about 30 seconds later.