Filter
Top Products
6. Troubleshooting
The dishwasher is capable of signalling a number of faults through the
simultaneous illumination of several indicator lights, with the following meanings:
FAULT DESCRIPTION
E1
Acquastop failure
The anti-flooding system has been activated. The
system is tripped in case of water leaks. Contact
the after-sales service.
E2
Safety level
The system which limits the water level inside the
dishwasher has been tripped. Interrupt the
program and switch off the dishwasher. Switch
the dishwasher back on, program it again and
start the washing cycle. If the problem persists,
contact the after-sales service.
E3
Water heating malfunction
The water is not heated or the heating
parameters are not correct. Repeat the washing
program; if the problem persists, contact the
after-sales service.
E4
Water temperature monitoring malfunction
Interrupt the program and switch off the
dishwasher. Switch the dishwasher back on,
program it again and start the washing cycle. If
the problem persists, contact the after-sales
service.
E5
Water intake malfunction
The appliance does not take in water or does not
do so correctly. Check that the water connections
are correct, the water intake tap is turned on and
the filter is not fouled. If the problem persists,
contact the after-sales service.
E6
Water pump-out malfunction
The appliance does not pump out the water or
does not do so correctly. Check that the drain
hose is not kinked or crushed and that the siphon
and filter are not fouled. If the problem persists,
contact the after-sales service.
E7
Turbine flow-regulator malfunction
The appliance is not able to "measure" the
amount of water loaded accurately. Interrupt the
program and switch off the dishwasher. Switch
the dishwasher back on, program it again and
start the washing cycle. If the problem persists,
contact the after-sales service.
33
User instructions