Filter
Top Products
23
WATER CONNECTION
Disconnect the appliance from the mains power
supply before starting operations.
• The ice maker and water circuit must be connected to a
water supply of potable and/or chemically purified water.
• The water connection must be carried out in compliance
with local regulations.
• The appliance is supplied with a water tube, 2.330 m. long,
already attached to the back of the product, and is provided
with a transition connector for connecting to the water
supply (internal bag).
• Remove the shipping tape from the gray coiled water tubing
on the rear of the appliance.
• Remove the protective cap from the end of the gray water
tubing.
• Connect the water tube (1) to the transition connector (2).
Finger tightening and then 1 to 2 additional turns should be
adequate.
• Connect the transition connector (2) to the household
water supply (3).
• Make sure that the water tube is not twisted.
• The appliance is pre-set for operation at pressures between
1.7 and 8.1 bar (25 and 117 PSI).
• Open the water tap. Check for and eliminate any leaks.
• The appliance does not require any adjustment or water
drain.
6gb33032.fm5 Page 23 Monday, May 23, 2005 2:17 PM