Filter
Top Products
Instructions for the user
16
7USINGTHEHOB
Before turning on the burners, make sure that the burner rings, cap
s
and grids have been fitted correctly.
In the ultrarapid burner, notch A must be aligned with pin B.
Grid C provided is intended for use with woks (Chinese pans).
Adapter D comes only with open grids models and is intended for us
e
with small sized vessels.
7.1 Ignition of the burners
The device is fit with electronic ignition. Simply press and
simultaneously turn the knob counter-clockwise on the low point flame
symbol, until the burner is ignited.
Concerning models with valves, push the knob for approximately 2
seconds in order to keep the flame burning and to activate the safety
device.
The burner might go off when the knob is released. In this case repeat
the aforesaid operation keeping the knob pressed for more than 2
seconds.
(Only where applicable)
Double-crown burners, controlled by two knobs, feature two ribs, a long
one corresponding to the small inner burner and a short one to the outer
burner.
Double-crown burners comprise an auxiliary and a rapid burner,
controlled by two different knobs which allow both burners to be used at
the same time or to select one or the other as required.
Should the burners go off accidentally in the models with valves,
a
safety device will trip after approximately 20 seconds to block the ga
s
outlet even if the cock is open.