Filter
Top Products
55
Instructions for the Installer
13. INSTALLING THE APPLIANCE
13.1 Electrical connection
The nameplate with the technical data, serial number and mark is in a
visible position on the oven door frame.
The nameplate must never be removed.
The appliance must be connected to earth in compliance with electrical
system safety regulations.
If a permanent connection is used, the appliance's power supply line must
be fitted with an omnipolar breaking device with contact gap of at least 3
mm, located in an easily accessible position close to the appliance itself.
If a socket and plug connection is used, check that they are of the same
type. Do not use reducers, adapters or junctions since they may cause
overheating or burns.
Operation at 220-240 V~: use a
H05RR-F three-wire cable (cable
of 3 x 1.5 mm
2
).
The earth wire (yellow-green)
must be at least 20 mm longer
than the other wires at the end
for connection to the appliance.