Filter
Top Products
42
Instructions for the Installer
8. INSTALLING THE APPLIANCE
8.1 Fitting the appliance in the top
This appliance is in class 3. The procedures required below must be
carried out by a skilled builder and/or joiner.
The hob can be installed on various materials, including masonry, metal,
solid wood and wood finished with plastic laminates, provided the material
is heat-resistant (T 90° C).
8.1.1 Fixing to the supporting structure
To install the appliance the opening “
B
” and the holes “
A
” shown in figure 1
must be made in the top; see figure 2 for the relative dimensions and
distances. The foam rubber strip “
C
” (Fig. 1) is supplied with the appliance,
and must be fixed with its adhesive side facing towards the supporting surface.
The area inside the dotted line marks the external dimensions of your
appliance. Make sure that there is at least
750 mm
between the hob burners
and any shelving placed vertically above them (Fig. 3). If the top is more than
20 mm thick, the hole required to install the hob is shown in figure 4.
1) 2)
3) 4)
The distance “Y” is the
difference between the total
thickness of the top and the
depth of the hole ø7, which is
always 20 mm.