Filter
Top Products
INSTALLATION SEZ SERIES COUNTERTOP STEAMERS
PAGE 6OPERATOR’S MANUAL 1181587
INSTALLATION
INSTALLATION
! CAUTION
Do not locate unit adjacent to any high heat or grease producing piece of equipment, such as a range
top, griddle, fryer, etc., that could allow radiant heat to raise the exterior temperature of the steamer
body above 130°F (54°C). DO NOT MOUNT ABOVE OTHER COOKING EQUIPMENT.
NOTICE
These installation procedures must be followed by qualified personnel or warranty will be void.
Local codes regarding installation vary greatly from one area to another. The National Fire Protection
Association, Inc. states in its NFPA 96 latest edition that local codes are the “authority having
jurisdiction” when it comes to installation requirements for equipment. Therefore, installations should
comply with all local codes.
The unit, when installed, must be electrically grounded and comply with local codes, or in the
absence of local codes with the National Electrical Code ANSI/NFPA 70-latest edition.
Canadian installation must comply with CSA-Standard (C22.2 No. 109-M1981 General
Requirements-Canadian Electrical Code, Part II. 109-M1981) Commercial Cooking Appliances.
NOTICE
EXHAUST FANS AND CANOPIES: It is recommended that the steamer be installed under a
ventilation hood. Consult local codes for proper installation of hoods. Proper ventilation is the owner’s
responsibility. Any problem due to improper ventilation will not be covered by warranty.
LEVELING: Unit must be level to assure maximum performance. Improper leveling may void
warranty.
Step 1: Unpacking
IMMEDIATELY INSPECT FOR SHIPPING DAMAGE
All containers should be examined for damage before and during unloading. The freight carrier has
assumed responsibility for its safe transit and delivery. If damaged equipment is received, either
apparent or concealed, a claim must be made with the delivering carrier.
Apparent damage or loss must be noted on the freight bill at the time of delivery. The freight bill must
then be signed by the carrier representative (Driver). If the bill is not signed, the carrier may refuse
the claim. The carrier can supply the necessary forms.
A request for inspection must be made to the carrier within 15 days if there is concealed damage or
loss that is not apparent until after the equipment is uncrated. The carrier should arrange an
inspection. Be certain to hold all contents plus all packing material.