Filter
Top Products
TROUBLESHOOTING SEZ SERIES COUNTERTOP STEAMERS
PAGE 34 OPERATOR’S MANUAL 1181587
TROUBLESHOOTING
Figure 17
Pressure Switch Check
Float Box Lid
A
ir Vent
Float Switch
Pressure Switch
1. DISCONNECT POWER AT CIRCUIT BREAKER.
2. Remove rear cover.
3. Remove wires B73 and B74 from pressure switch “COM” and “NO” terminals.
4. Open door.
5. Place test leads on “COM” and “NO” terminals as shown.
6. Check continuity. There should NOT be continuity. Replace as necessary.
7. Remove pressure switch from lid.
8. With test leads on “COM” and “NO” terminals as before, gently blow into pressure port and check
continuity. There SHOULD be continuity. Replace as necessary.