STRATOSTEAM COUNTERTOP STEAMER INSTALLATION
STEP 2B: ATTACH TO COUNTERTOP
If the steamer is to be installed on a countertop or other surface without using legs, the steamer must be sealed to the
surface to prevent any water, grease, etc., from accumulating under the steamer. The steamer can be bolted to the
surface, but will still have to be sealed. Make sure that the installed steamer is level before applying the sealant. The
installer may use GE
®
or Dow Corning
®
RTV type sealant. Consult local code for exact requirements.
1. Lower the steamer gently onto a level surface. Never drop or allow the steamer to fall.
2. If desired, bolt the steamer to the surface (use 3/8-16 bolts to fit the threaded holes used by the legs).
3. Make sure that the steamer is level (both side-to-side and front-to-back).
4. Apply sealant around all four bottom edges of the steamer (see Figure 5).
5. Go on to Installation Step 3.
Figure 5
Installation on Countertop
R
T
V
T
y
p
e
S
e
a
l
a
n
t
STEP 2C: MOUNTING ON CABINET BASE
If the steamer is to be mounted on the optional cabinet base, first attached the legs to the cabinet base (if not already
attached). Then place the steamer on top of the cabinet base and line up the threaded holes on the bottom of the
steamer with the holes in the cabinet-base top. Secure the steamer to the base with four 3/8-16 bolts. Go on to
Installation Step 3.
STEP 2D: STACKING TWO STEAMERS
If two steamers are to be stacked, mount the lower steamer first on either legs (Step 2a), a countertop (Step 2b), or
the optional cabinet base (Step 2c). Remove (if present) the four chrome-plated plugs from the holes in the top panel
of the lower steamer. Place the upper steamer on top of the lower steamer and line up the threaded holes on the
bottom of the upper steamer with the holes in the top of the lower steamer. Secure the upper steamer to the lower
steamer with four 3/8-16 bolts. The remaining steps of the installation must be performed for both steamers (they do
not share any connections internally).
OWNER’S MANUAL 1185290 PAGE 15 OF 50