Filter
Top Products
Continuous Loss-in-Weight Blenders Chapter 3: Installation 46
The Following screens will appear. This data is provided for trouble shooting blender stability
problems. If you are not getting a steady system indication or if you are getting an unstable
system alarm you can check here for the problem. This is a first in first in first out table. It
takes an average and gives you a percent differential. If the steady flag is a “1”, the hopper is
steady. If it is a “0”, it is not steady. This means that the percent differential is greater than
what the value is set to on the advanced hopper page. The mass flow FIFO works the same
way, only you have to calculate the % differentially manually.