Filter
Top Products
SSE 2
Assembly instructions 4-7
4.4.3. Mounting onto mixing hoppers with lateral inlet
A material hopper VT 1.0 is required:
1. Mount the material hopper onto the
swan-neck of the mixing hopper.
2. Mount the unit onto the intermediate
hopper.
F Observe the bearing capacity of the machine flange.
4.4.4. Mounting onto dosing station DT 30
A dosing hopper DT 30 (12.6”, 320 mm high) is required:
1. Mount the dosing hopper directly onto the dosing container of the dosing station DT
30.
2. Mount the unit onto the dosing hopper.
F Observe the bearing capacity of the machine flange.
Figure 7: VT 1.0
Figure 8: DT 30