Filter
Top Products
9
L. Remove auger assembly from the freezing cylinder
and remove auger blades.
M. Remove rear seal and o-ring from auger.
N. Remove drain tray, drip tray and drip tray grid.
3.9 CLEANING THE FREEZER PARTS
Place all loose parts in a pan or container and take to the
wash sink for cleaning. To clean freezer parts, refer to the
following steps:
A. Prepare detergent water by mixing 2 oz. of Palmolive
detergent or equivalent in 2 gallons of 90° to 110°F
(32° to 43°C) water. Place all parts in detergent
solution and clean with provided brushes. Rinse all
parts with clean 90° to 110°F (32° to 43°C) water.
B. Wash the hopper and freezing cylinder with the 90°
to 110°F (32° to 43°C) detergent water and brushes
provided (Refer to Figure 3-7).
C. Clean the rear seal surfaces from the inside of the
freezing cylinder with the 90° to 110°F (32° to 43°C)
detergent water.
3.10 SANITIZE FREEZER AND FREEZER
PARTS
A. Use Stera-Sheen or equivalent sanitizing solution
mixed according to manufacturer's instructions to
provide 100 parts per million strength solution. Mix
sanitizer in quantities of no less than 2 gallons (7.5
liters) of 90° to 110°F (32° to 43°C) water. Any
sanitizer must be used only in accordance with the
manufacturer's instructions.
B. With the large brush provided, sanitize the rear of
the freezing cylinder by dipping the brush in the
sanitizing solution and brushing the rear of the
cylinder.
3.11 ASSEMBLY OF FREEZER
To assemble the freezer parts, refer to the following steps:
NOTE
Petrol Gel sanitary lubricant or equivalent must be
used when lubrication of parts is specified.
NOTE
The United States Department of Agriculture and
the Food and Drug Administration require that lubri-
cants used on food processing equipment be certi-
fied for this use. Use lubricants only in accordance
with the manufacturer’s instructions.
A. Assemble all o-rings onto parts dry, without
lubrication. Then apply a thin film of sanitary
lubrication to exposed surfaces of the o-rings. Also
apply a thin film of sanitary lubricant inside and
outside of front auger support bushing, and to the
inside and outside of stator support bushing.
B. Assemble the rear seal onto the auger with the
large end to the rear. Be sure the o-ring is in place
before installing the rear seal (Refer to Figure 3-8).
C. Put a small amount of white Hex Drive Anti Seize
(spline lube) on the hex end of the auger shaft. A
small container of Anti Seize is shipped with the
freezer.
Figure 3-7 Cleaning Freezer Cylinder
Figure 3-6 Removing O-Ring
Figure 3-8 Auger Rear Seal