Stoves 83138305 Range User Manual


  Open as PDF
of 40
 
INSTALLATION INSTRUCTIONS - GAS
CONNECT TO THE GAS SUPPLY
The inlet to the cooker is ½” BSP internal
situated at the rear right corner. Fit the
bayonet connection. This should be
locatedsoastoensurethattheexible
connector hose does not kink.
Undernocircumstancesshouldtheex-
ible connector be allowed to come into
contactwiththeverticalovenuetubes
on the rear of the appliance.
Usea900mm-1125mmlengthofexible
connector.
Ensure that all pipework is of the correct
rating for both size and temperature.
Natural Gas - Flexible connections should
comply with BS 669. Parts of the appli-
ance likely to come into contact with a
exibleconnectorhaveatemperaturerise
of less than 70°C.
After installation, make sure all connec-
tions are gas sound.
COMMISSIONING
Burner aeration
Allburnershavexedaerationandno
adjustment is possible.
Pressure setting
G20 Natural Gas @ 20 mbar
Pressure test point
Use the oven injector.
Grill
Open the top oven / grill door. Push in
and turn the top oven / grill control knob
clockwise to the ‘FULL ON’ position. Hold
the control knob in, and press the igni-
tionswitch(iftted)orholdalighted
match or taper to the burner. Hold the
control knob in for 15 seconds. Do not
hold the control knob in for longer that 15
seconds. If the burner fails to light within
this time, release the control knob and
wait one minute before attempting further
ignition. until the burner lights.
Hob burner
Turn the control knob to the FULL ON
position, wait a second before pressing
the ignition switch or holding a lighted
match or taper to the burner. Hold the
control knob in for 15 seconds. Do not
hold the control knob in for longer that 15
seconds. If the burner fails to light within
this time, release the control knob and
wait one minute before attempting further
ignition.
Ovens
Open the oven door. Turn the control
to the FULL ON position and press the
ignition switch, or hold a lighted match or
taper to the burner. Hold the control knob
in for 15 seconds. Do not hold the control
knob in for longer that 15 seconds. If
the burner fails to light within this time,
release the control knob and wait one
minute before attempting further ignition.
Before leaving the installation
1. Place all the loose parts of the
cooker into position.
2. Show the customer how to
operate the cooker and give them this
handbook. Thank you.
 previous next