Filter
Top Products
16
SUB-ZERO MODEL 315W OPERATION
CLEANING THE CONDENSER
The air-cooled condenser should be vacuumed
two to three times per year to remove any lint
that may have been drawn into the condenser.
To access the condenser, use a phillips head
screw driver to remove the kickplate as shown
in the illustration below. Then using a soft
bristle brush, vacuum to remove dust and lint
from the condenser. Refer to the illustration
below.
IMPORTANT NOTE:
To avoid bending the
condenser fins, be sure to vacuum in the direc-
tion of the fins (up and down).
CLEANING
EXTERIOR CLEANING
To clean the classic stainless steel exterior of
the Model 315W/S, use a soft, nonabrasive
stainless steel cleaner like Signature Polish
(see side note) and apply with a soft 100%
lint-free cloth.
If anything spills onto the door gasket, wash
with soap and warm water to remove. Rinse
and dry thoroughly.
GLASS DOOR CLEANING
The glass door panel can be cleaned using any
standard glass cleaner available on the market
today.
INTERIOR CLEANING
To clean interior surfaces and removable parts,
wash with a mild solution of soap and luke-
warm water with a little baking soda. Do not
use vinegar. Rinse and dry thoroughly. Avoid
getting water on lights, control panel and the
solid cherry wood facing on the shelves.
Do not use abrasive cleaners or cloths on any
of the interior or exterior surfaces, including
the glass door panel.
CONDENSER
FINS
Kickplate removal Cleaning the condenser
SIGNATURE
POLISH
Signature Polish
is available from
Signature Limited
Laboratory,
P. O. Box 13436,
Dayton, Ohio
45413-0436, or
call 877-376-5474
(toll free).
Before cleaning the condenser and other
routine maintenance, shut off power at
the circuit breaker suppling power to the
electrical outlet.
Failure to clean the condenser could
result in temperature loss or mechanical
failure or damage.