Filter
Top Products
Dimensions in parentheses are in
millimeters unless otherwise specified.8
SUB-ZERO MODEL 315W INSTALLATION
LEVELING THE UNITBLOCKING FOR SAFETY
A metal antip-tip bracket and screws are
provided with the unit. Attach the anti-tip
bracket to the top of the unit, opposite the
hinge side. The bracket offset flange should be
facing up with the two oblong holes also in the
front. Once the unit is moved into position,
open the door and secure the anti-tip bracket
to the countertop. Refer to illustration below.
IMPORTANT NOTE:
The unit must be leveled
prior to placing it in the rough opening.
There are four leveling legs on the Model
315W, one at each corner. To assist you in
adjusting the front leveling legs up or down,
tip the unit back slightly to allow access to
leveling legs. Use a pliers and place around
the leveling leg, or use a screwdriver and turn
the front leg to make necessary adjustments.
To level the unit, turn the leveling legs counter-
clockwise to raise the unit, or clockwise to
lower it. Refer to the illustration below.
To assist you in proper leveling, we recom-
mend using a 2' (.6 m) level. There are two
recommended level locations: along the top of
the unit or on either exterior side of the unit.
These positions will help determine the vertical
and horizontal level point. In order to access
these leveling positions, the unit will have to
be slightly out of the opening.
Place the unit in the rough opening. Make sure
the power cord is plugged in before position-
ing the unit. Turn the power back on to the
electrical outlet.
Shut off the power to the electrical outlet.
Anti-tip bracket Adjusting leveling legs
To prevent the unit from tipping forward
if multiple loaded bottle racks are pulled
out at one time, and to provide a stable
installation, the unit must be secured in
place with an anti-tip device.